Inletting blind mag stock for savage DBM

[wintermute76]

One of my coworkers recenty bought a 10 FP .308 centerfeed blind magazine model, non accustock.
I'm looking at replacing my 10FCP McMillans mag setup with a CDI AICS unit.

Wondering if we can inlet his stock for my factory DBM. Possible?

[aubie515]

Anything is possible...it just takes money. Send it to Jeff at CDI...he can inlet the stock.

[82boy]

Yes it can be done and Sharp Shooter Supply does them many times a day. This is not a project you can do with a dremel, at home.

[Carvera]

Would it not be cheaper to buy a factory take-off stock that is inletted for the DBM/HFP, than to have the work done on a factory stock?

[wintermute76]

I can use the mill at work to do it, one perk of being a machinist.
From the first glance at his stock on the outside, it looked like it's the same tool to mold them, just using a coring insert on the DBM models to mold the pocket.

You're right, buying a takeoff stock would be the easiest route, and that's what I told him, but it's not my rifle.

I was just wondering if it was feasible or not.