Need advice on mounts and rings

[Blackwolff]

Hello everyone

I have a Vortex Viper 6.5 - 20 x 50 pa. I need to mount on a model 10 fcp-k 308 and unshure wich mounts to use. Have been told to use the Leupold Standerd or the Burris quick detach. Any advice would be helpfull.


Thank you

[1983Weatherby]

I like to use EGW 1 piece base and Burris XTR low rings. Nice solid setup.

[missed]

I'm running the egw base and Burris mediums on mine.

[Blackwolff]

Though I would need a high ring with how high the bolt comes up

[stangfish]

I can think of but one reason you would need high rings on a savage. Thay is if you run a chasis system like XLR. The only other reason might be if you had a 60mm objective.

[missed]

I have enough clearance with the mediums I think I would try lows if I didn't already have the comb risers built for both guns.

[stomp442]

Get the Burris signature zee rings. They also come with additional 10 moa ring inserts to help get the best moa travel out of that scope. Not to mention being the best solid and square rings you can get.

[davemuzz]

Get the Burris signature zee rings. They also come with additional 10 moa ring inserts to help get the best moa travel out of that scope. Not to mention being the best solid and square rings you can get.

+1 on the Signature rings. Order the low rings if your they will allow your scope clearance for your bolt and your scope's objective lens. Depending on where you order them from, you can usually return them it they don't fit.

Lower is always better when it comes to scope ring height and bikini things.

Dave

[BobT]

+1 on the Signature rings. Order the low rings if your they will allow your scope clearance for your bolt and your scope's objective lens.
Dave

I'm with the other guys on the Signature rings, as far as I know though they only come in medium and high. The medium ones should work fine with your setup.

Bob

[thomae]

+1 on the Signature Zee rings.

http://www.burrisoptics.com/sigrings.html

1" models come with the zero inserts only and are available in medium and high.
30mm models come with the zero and + .010 inserts and are available in Med, High, and Extra High.

Signature Zee Rings

	Black	Matte	Nickel
Medium	420520	420521	420522
High	420530	420531	420532
30mm Medium*		420588
30mm High*		420587
30mm Extra High*		420585
*30mm comes with "zero" inserts and +/- .010 inserts for both front and rear rings

Ring Heights
	Low	Medium	High	Extra High
Std. 1" & Sig 1"	.150	.270	.390
Std. 30mm & Sig 30mm		.180	.300	.420
Zee 1" & Quick Detach 1"	.130	.255	.450
Zee Sig 1"		.270	.420
Zee 30mm Incl. Sig		.205	.330	.582
CZ (all)		.480
.22 Signature Deluxe		.400	.793
1" .22 rings (all)		.295	.450
Dimensions listed are from the bottom of the scope tube to the bottom of the ring. To securely mount rings and bases, tighten to the following specification: Ring Tops - 18-24 in./lb. Bases - 28-32 in./lb. Rear windage base screws - 40-45 in./lb.

[Blackwolff]

thanks everyone for heading me in the right way to mount my scope

[xpdchief]

I used a set of Talley Light Weight Scope Mounts (#740725) from SWFA.