can i fit this boyd's to my rifle?

[coldmaker]

my rifle is an model 16 FLHSS in 7wsm.
so it's a left hand,
centerfeed short action with hinged floor plate.
can i fit this stock?
http://www.boydsgunstocks.com/produc...18992&cat=1219

if it will only fit detachable mag, can i convert my rifle to D/M?

thanks!

[missed]

You can convert to DBM just have to buy a mag and the bottom metal.

I can't wait until they have the DBM tacticool out.

I don't see why it wouldn't fit for you.

[stangfish]

Sometimes there is spacing problems. Those can be worked around by using a spacer(washer) or other means(dremel/grinder). Your action screws may need to be replaced or fitted.

[coldmaker]

Thank's gentlemen.
Somebody knows where i can get all i need for this in canada by any chance?

[stangfish]

Time to make a trip to USA. Change your stock here and then go back.

[thomae]

Recheck the laws. Someone posted some information here leading us to believe that the $100 (US) limit on parts shipments to Canada had been increased to (Was it $500?)? They included a link to the documentation, as well.

Edit: Found a valid source/reference in the Federal Register.
https://www.federalregister.gov/arti...ents-exemption

Please note that this new ruling applies to exporting from the USA. I don't know anything about Canadian rules or restrictions on importing into Canada.

[coldmaker]

thank's Thomae

there's nothing in the Canadian regulation against it.
in fact the american laws are far more restrictive to us.
if for canadian laws only i could cross the border buy up to 5000
shell or cartridge and come back.
as long as i pay the taxes at the border. but the US export laws say otherwise...
i'll contact boyd's and see what they say about it.

thank's