you're on the right track. I'd get longer screws cut the heads off. Tape the body of the screw from where it meets the action till it exits the stock and make sure the action will still drop into the stock. Coat those screws with release agent including the taped area and bed as instructed. After bedding is cured remove the screws before removing the action from the stock. I've done several of these with good success. Make sure you sure plenty of release agent and get everywhere the bedding material may or will get. you can run a drill bit up thru the screw holes when the action is out to open back up the pillars. I do this with just a bit no drill.
Follow Richard Franklin's instructions and everything will come out great.
jim
Bookmarks