Case Drawing 6.5x300 WSM

[35Whelenshooter]

I would like to find the blue print/case drawing of the 6.5x300 Winchester Short Mag. I will be in a holding patteran for about six months until I received my loading dies from CH4D. I would entertain any information that our fellow Savage wildcaters would have to offer.

Thanks.

[BillPa]

Try emailing Dave @ PTG. He may have the reamer print. You can also figure it out using 4D's drawing and the SAMMI prints for the 270-300 Wizzems

http://www.4-dproducts.com/displayitem.php?rowid=119&tname=rental
http://www.saami.org/specifications_...ex.cfm?page=CC

Bill

[stomp442]

A few years ago when I built mine Lee had dies readily available for under $40. I believe I purchased them from midway. Might check there if you don't want to wait.

[yobuck]

A few years ago when I built mine Lee had dies readily available for under $40. I believe I purchased them from midway. Might check there if you don't want to wait.

i bought lee dies also for my 6.5 wsm on ebay.
id reccommend looking for norma brass as opposed to win. brass.

[jibben]

i bought lee dies also for my 6.5 wsm on ebay.
id reccommend looking for norma brass as opposed to win. brass.

same here. ebay & Norma