Reply With QuoteSo, how do you load it?
I picked up a used Ultimate Varmint this week to see if I could get it to work with the Edge/Axis action. The answer is yes.
The first thing I did was relieve the rear for the weird trigger set up...
Then drilled the hole for the front and added a spacer. I also used some epoxy putty to make a mold for the recoil lug. I covered the recoil lug in grease, got the putty put in place and bolted it together..
I used the follower and mag from a BM, SA, SF, set up and it cycles nicely.
Here are the end results with a Hog Hunter .308 Barrel and a Tri Delta brake. I have a stainless brake on the way and will update with pics.
I also has an EGW mount, Burris XTR Lows, and a Weaver 3x12x50
So, how do you load it?
"As long as there's lead in the air....there's still hope.."
The same as my blind mags. I will admit it is a little tougher but completely manageable.
I also forgot to add that the bolt release area had to be enlarged a bit.
Last edited by cheapshot; 04-17-2013 at 08:32 PM.
Do you know how accurate it is being retro-fitted?? Certain ways the shot pattern strings?
I have yet to fire it. I did the barrel swap yesterday as well. I don't anticipate any accuracy issues however. the barrel is free floated and only the action is touching the aluminum blocks.
Sounds pretty straight forward and sturdy to me! haha I will stand-by for a range update when you get too it! :D
great job boss..i knew someone out there was going to get that chaote stock and drop that axis in it ..... if there is a will there is a way..no aftermarket axis stocks is the way to savage shooter member inventions...here is my axis
Finally was able to take it to the range yesterday. Put 54 rounds down range. I gotta say that this thing is so much to shoot. All i was able to get my hands on were 180gr Rem core lokts. I had 6 rounds of federal match 168. With core lokts it was shooting near MOA but not quite. The final 6 shots with the factory 168s took it to under MOA. This is a brand new barrel and I expect it to tighten up with hand loads and some more pills down the tube. I feel certain it is capable of 1/2" groups with the proper loads.
Nice Job!!!
6CM
how in the world did you accomplish this? i have actually wanted a design like this for my XP 308Originally Posted by plutonium
great job boss..i knew someone out there was going to get that chaote stock and drop that axis in it ..... if there is a will there is a way..no aftermarket axis stocks is the way to savage shooter member inventions...here is my axis
yes i know im digging up an old thread but didnt this stock have a v-block bedding system in it before you started,,, and yes i know about boyds and i know i could just get the pro varmint (tacticool) but i want the choate tactical for the aluminum block and weight
also can you give details
like which stock was this, the LA or SA center feed or SA standard and the original screw spacing
Members who have read this thread in the last 1 days: 0
Posting Permissions
Bookmarks