You might try one of these: http://www.combatstocks.com/Choate_S...int_Stocks.cfm
Comes with the Tactical Stock but not the Ultimate Sniper or Ultimate Varmint stocks.
Ok.. So who has a Choate Ultimate Sniper Stock and has installed a Harris Bipod.
The Anschutz style rail sits high and causes the bipod to not make contact with the stock. I've tried all the adapters to no avail. If I can't figure something out and soon, this stock is going away (hint...hint, and yes I am a paid member and can sell here).
Suggestions? Selling the stock is an option because I am at my wits end.
You might try one of these: http://www.combatstocks.com/Choate_S...int_Stocks.cfm
Comes with the Tactical Stock but not the Ultimate Sniper or Ultimate Varmint stocks.
Thanks. For $23, it is worth a try.
Maybe try filing the rail down.... Mill or belt sander? Free
Just to give everyone an update. Got one in from Combat Stocks. Works PERFECTLY. I'll keep the stock and save up for an XLR to match its big brother (260 Rem build that is in flight).
I'm kind of late to the party, but I had the same complaint about the Choate-supplied adapter with an Ultimate Varmint stock (same rail design as the USS). I can't remember for sure where I got it (Midway, I think), but I found a simple sling stud that is made for railed forearms and that has worked for me. It's basically just a standard sling stud made on a flat piece of steel that slides into the rail and then secures with a set screw. It was less $10 if I remember right. Just look around for sling stud adaptors made for Anschutz-style rails and you should find it. But beware, there are ones made for different rail sizes, and I can't remember for sure what size the Choate rail is.
[b]A witty saying proves nothing - Voltaire (1694-1778)[/b]
Which Harris Bipod did you install?
Bookmarks