Brand new M12 FV .223 Rem pulls cases out a bit, then drops them so I have to fish them out.
Not every one, but most.
Shot first time yesterday.
Is there an easy fix?
Thanks;
joe b.
This might help you with extraction
The .140 dia ball helps a lot of the times
I did not read the last post on the thread, if they are not available send me a PM with your address and I will send you one
Jack
http://www.savageshooters.com/showth...40-Detent-Ball
Last edited by JW; 01-31-2013 at 07:52 AM.
Send me your info and I will send you one make that two they extra one is for the one that goes flying.LOL
Part two detent balls 101
Hey Shooters, Here is bolt parts 101 the pin is they ejector and the square part is they extractor, put the bolt in a vise pointing up like your looking strait at it, push they extractor towards they out side of the bolt, hold a piece of duct tape over the bolt so when the ball goes flying it will catch it, when you put the new one in hold it down with a small screwdriver and slide the screwdriver back as your sliding they extractor in, the clamping power that this oversized extractor ball gives is significant, it could make a difference between a stuck case and not.
Tanks Dean
PS: tanks Jack
Last edited by scope eye; 01-31-2013 at 07:59 AM. Reason: spellink
RUMs are like woman in Stiletto heals, you know they are going to put you in the poor house, but that has never stopped anyone from pursuing them.
Scope eye is a good chap.
For those of you who need it, here's some more reading on the detent ball upgrade:
http://www.savageshooters.com/conten...t-Ball-Upgrade
Thanks, I'll get one and install (or lose) it.
Thanks;
joe b.
Posting Permissions
Reply With Quote
Bookmarks