Weaver T36 on Savage mark II BV?

[TrxR]

Anyone here use a T36 on their Savage? I am looking for suggestions on Ring height and whether new mounts will be needed.

Thanks

[scope eye]

I have Millitt med with that same set up, the high rings are 1/8" higher,

Tanks Dean

[TrxR]

So you are using the factory bases and Millett medium rings and a T36 on your BV? Whats the clearance like?

Thanks

[GSRswapandslow]

If you're using a T36....get signature zee high. If weight is an issue, get Kelby standards

Sent from my DROID X2 using Tapatalk 2

[TrxR]

Weight is not an issue. I have been thinking about using the burris just wasnt sure which height. Will I be able to use the factory bases on the BV with the High Burris rings or will I still need higher bases? This Rifle is for my Cousin as I already have a 40x setup with a T36 and Burris Signature Zee Rings

[scope eye]

The Burris high rings are almost .600 you should be fine with those.

Tanks Dean

[TrxR]

How high is it from the top of the barrell to the top of the factory bases?

Thanks

[scope eye]

On my rig the barrel is flush with they action, and then steps down 8" further down the barrel, but the scope bell is over the flush part.

Tanks Dean