1st - I have to say it
stand advised -as with any firearm mod- work
this can kill you or someone else if you screw it up
dont even try it if you dont feel completly comfortable with doing it
and if you do - this or any other mod to any firearm
PLEASE ---------------
bump slap test it -slam bolt foward harder than normal before using it
to make sure the firing pin stays in cocked position

one difference in LE accu triggers , Target accutriggers ,and regular accu triggers is the springs
Ive heard it said the sear is also differnt on Target models -
but there is for sure a difference in the wieght of the springs

if you are a gunsmith -Savage will sell you these springs
if your not
you can still safely & easily mod the existing springs
to have a SAFE 1lb pull weight
you could even go less or more depending on preference

so here is how I mod the REGULAR accu trigger to about 1lb pull wieght -

remove rear spring -sear spring-
then move blade spring to rear position
it will be upside down from original position
the bottom of spring is smaller than the hole the original rear spring threaded into - & wont thread into it
it will simply set in the hole - and work fine

the top of the spring will work as is
OR
you can bend the tip of it up to fit into the hole in the receiver
this is not completly necessary -it will work fine without this step
I do it because I can
it takes 2 pair of needle nose & a lot of pateince
just bend top coil till it looks like original or close to it

next take a ink pen spring and replace the foward or blade spring
I use about a 1/2 of a ink pen spring
all this spring needs to do is return the blade to its foward position-
this spring also adds to the total pull weight

the top coil or two of it can be slid over the little bump
on the blade with your fingernail or a small screw diver
just bend the tip of the bottom coil down
all it has to do is stay in the hole

you could just make a new rear spring
but the reason I use the blade spring instead of making a new sear spring
is - the blade spring is a 1 lb spring- same weight spring as LE -law enforcment model- accutriggers use in the rear position
and because whatever spring is used in front position also adds to the total pull weight

in my opinion the accutrigger is the SAFEST - most USER FREINDLY -trigger out there
thats why we are seeing very simular trigger design on other makes
were also seeing barrel nuts & floating bolt heads on several other makes
imitation is most sincere form of flattery
I like and use all makes of firearms
but only accurate ones are interesting enough to use
the others are collectables
Savage Stevens firarms are accurate by design
and are very user freindly to adjust and modify
change caliber ect,........


before mod




after