I got a Boyds stock for my Stevens 200 today. I started putting it all together and it all went just fine until the trigger guard. I block sanded the plastic trigger guard down to where it will fit the stock but I didn't realize the front part of the trigger guard was thicker than the hole was deep in the stock. I looked at the steel replacement guards on Midway's site and they are thin like mine needs to be. I figure I will grind the excess off of mine till it will work but I have one question. There is a little tab of plastic that sticks up on the edge of the plastic guard where it goes up in the stock. It doesn't seem to do anything that I can see. Is it something thats cast into the guard to get it out of the mold? Should I grind it off too since the metal ones don't have it? What say the Savage Gurus?