???
The new marbles tang site has a start hgt of 1.7 to 2.12 inches from base to center of hole.
Now, if I put that on my rifle, looking at my rear sight and lining it up with the front,and the tang, the tang is a lot higher than the rear sight. Won't the tang sight now be shooting way, way high at 100 yds ?
Can anyone give me some center to peep hole measurements of the back of receiver of their guns, so I have some sort of idea where I should start with regards to the peep start height ? I don't mind shooting paper, however it is only 0 outside and I would like to start with it on paper.
The 99 is a 300 savage, 24 inch barrel,150 grn rem factory core locts, I normally have this rifle sighted in for 100 yds, but won't mind sighting it in for 200.
Any help in this is appreciated.