Bolt Size and replacement bolts for Savage 10 FLCP-k

**missed** · 01-15-2013, 11:14 PM

Well I went to retorque the bolts on my gun tonight and the last time I did it all I had was one of those stupid ball type drivers in 5/32" now I have rounded the heads off bad enough that the screws wont torque. What size are they and do yall have a good place for replacements? I would rather have torx if I can get a hold of them.

Thanks!

Jake

jibben · 01-16-2013, 05:24 PM

standard 1/4" fine thread or 1/4X28

**missed** · 01-16-2013, 05:42 PM

Thanks, I'm heading to the hardware store this afternoon too get some.

**missed** · 01-17-2013, 10:25 AM

Does anybody have a source for the 1/4-28 x 1.5" torx cap screws? I'm wondering if I can drill my hole by bolt release down far enough to use a regular socket cap torx screw instead of the button heads.

**Bossman** · 01-17-2013, 03:09 PM

This tip from Scope Eye sure has saved me a ton of aggravation since I tried it- Thank you Dean.
http://www.savageshooters.com/showth...crews+stripped