standard 1/4" fine thread or 1/4X28
Well I went to retorque the bolts on my gun tonight and the last time I did it all I had was one of those stupid ball type drivers in 5/32" now I have rounded the heads off bad enough that the screws wont torque. What size are they and do yall have a good place for replacements? I would rather have torx if I can get a hold of them.
Thanks!
Jake
standard 1/4" fine thread or 1/4X28
Thanks, I'm heading to the hardware store this afternoon too get some.
Does anybody have a source for the 1/4-28 x 1.5" torx cap screws? I'm wondering if I can drill my hole by bolt release down far enough to use a regular socket cap torx screw instead of the button heads.
This tip from Scope Eye sure has saved me a ton of aggravation since I tried it- Thank you Dean.
http://www.savageshooters.com/showth...crews+stripped
Bookmarks