Reply With QuoteYou say it's an older model 10....does it have the trigger guard bolt release, or the standard side release?
Putting an older model 10 action with the 4.4" spacing into an accustock. I believe I have everything I need, but can't figure out for the life of me how to install the sear spring for the trigger guard release. If any of you guys have a pic of your action/trigger assy installed with the trigger guard bolt release I'd sure appreciate a couple pics!
You say it's an older model 10....does it have the trigger guard bolt release, or the standard side release?
"As long as there's lead in the air....there's still hope.."
It's and older model 10 receiver with the side release, it was an early predator model with the 4.4" spacing and single feed blind magazine. I stumbled on to a new accustock with the bottom metal and magazines. Got what I needed (what I believe I needed anyway) from Savage last week. The scematics clearly showed a different style sear/release, pin and spring assy, so that's what I ordered along with the trigger guard along with the relase components. It looks like this stock was set up with the trigger guard release. I got everything mocked up and fitted into the stock, all seems well except where in the heck does the new sear spring go with the new sear. I double checked on Savage's website with the 2 serial numbers that the trigger brackets are the same...
Last edited by jefo1; 12-26-2012 at 05:51 PM.
Spring 4B in the pic is the one that's got me lost
https://s3.amazonaws.com/savagefiles...der/RNFDBM.JPG
Members who have read this thread in the last 1 days: 0
Posting Permissions
Bookmarks