It won't affect much. It won't cost much either, I bet you'll only get charged for the crown job.
You could also just get a thread protector and forget that it's there. It will keep up the resale value of the barrel.
I need some advice about a barrel I might be getting. It's a 26 inch heavy stainless .204 barrel that's threaded for a brake. Since I don't want a brake, i'm considering having it turned down and crowned. Will the little bit of length removed affect anything? I can make some calls tomorrow, but any idea what it might cost?
Sent from my HTC Hero S using Tapatalk 2
It won't affect much. It won't cost much either, I bet you'll only get charged for the crown job.
You could also just get a thread protector and forget that it's there. It will keep up the resale value of the barrel.
"Muzzle velocity is a depreciating asset, not unlike a new car, but BC, like diamonds, is forever."-German A. Salazar
Use a tread protector, dont cut it, it is an enhancement to the barrel.
Thanks for the input guys. Maybe this thread will help the next guy. I ended up just getting my money back, so I'm back on the market for a barrel.
Sent from my HTC Hero S using Tapatalk 2
Bookmarks