OK folks, got a question here.
Picked up a 110, serial starts with F, in 30-06. I pulled it out of the stock, tuned the trigger, went to install it back in the stock. Get everything lined up, and tighten down the front action screw.. It stops before the action is tight in the stock. The rear pulls the action tight, but I'm still worried that the front action screw seems to be bottoming out before I get it tight in the stock...
Is this normal? Should I be tightening the rear first? Should I shave the bolt down a hair or ad a washer in the screw hold to make the screw feel shorter?
This is a wooden stock, and original to the rifle from what I can tell. I bought used, and the rifle was barely shot. The rifle doesnt seem to shoot for crap. 1" at 50y. It could be the load, and I'll probably feed some factory ammo through it later, if I dont rechamber when I upgrade the barrel. The load used, 46gr of H4895 under a 165gr Hornady interlock. CCI Large rifle primer.
Reply With Quote
Bookmarks