The trigger on one of my 110 actions is too tight / hard to pull. I've run out of options on making it lighter. I've replaced the spring with a thinner spring wire, polished the sear & it's contact point, cleaned & lubed, aligned, cursed & kicked the wall....

I think I've covered everything.

The only way I can explain this is, it's hard to pull to the point where it takes alot of concentration on trigger pull because if I don't pay attention, I'll yank the trigger & pull the shot.
Almost feels like a burr grabbing & then *snap*.... A crisp, clean break.

I guess it's time to open up the 'ol wallet & go with a new trigger.
By the way, this is an older action I'm referring to. Made around '97 - '98...

What's the preferred trigger these days? Timney or Rifle Basix?

If any of y'all have any experiences with either one - good or bad - i'd like to hear it.

Thanks.

Frank in Fla