Just recieved a tactical bolt handle a rplacment for the 11FCNS in 308.
After removing the bolt and decocking to insert the allen key in the rear nut ,turning clockwise I find it impossable to turn the nut .Is there something I am missing in the instructions ?
Lefty loosy, righty tighty.! If you're looking at the rear of the bolt you need to turn the bolt assembly screw counter clockwise to loosen it. They are typically very tight, if you do a search on bolt handle removal or replacement you should find a couple tricks to help you.
Bob
It's better to shoot for the moon and hit the fencepost than to shoot for the fencepost and hit the ground!
put it on the floor and step on it for weight. there TIGHT and make a loud snap when they brake free.
.223 Rem AI, .22-250 AI, .220 Swift AI .243 Win AI, .6mm Rem AI, .257 Rob AI, .25-06 AI, 6.5x300wsm .30-06 AI, .270 STW, 7mm STW, 28 nosler, .416 Taylor
yep. counterclockwise to remove. clockwise to install. And they are very tight, but do as Blue Avenger said and it will come loose no problem.
”I have a very strict gun control policy: if there’s a gun around, I want to be in control of it.”
~Clint Eastwood
Forget about putting that "TACTICOOL" bolt handle on your rifle and send it to me! ;D
Foot pounds are determined by whether you weight 155lbs. or are a 285lb linebacker.
I did three of them today with bolt handles I got from SSS. I used a 1/4" drive and a torque wrench. Two of them required better than 25FP to break loose and the third was barely finger tight. Who knows?
Members who have read this thread in the last 1 days: 0
Posting Permissions
Reply With Quote
Bookmarks