I took off my three-screw trigger to bed a rifle.
I have shimmed it and lapped the sides of the trigger so it should be a bit smoother than before.

Here is my issue.
I am reassembling it and was wondering if anyone had any tips or suggestions to ease the problem of getting the sear and sear spring back in place (under spring tension) without allowing the sear spring to "SPROINGGGG" and fly away, never to be seen again.

I know how all the parts go together, but was hoping there was a trick to limit the possibility of my losing the spring.

Thanks in advance for your suggestions.
Cheers,
Thomae