Ever since getting back into reloading and shooting; I've had problems with getting CCI primers to seat flush. Today, I loaded up some 7mm-08 and had 3 or so where the primer isn't quite flush with the case head. Hard to see, but, I can feel it with my finger. I'm using an old Pacific single stage press. I use lots of pressure on the ram handle, and I'm thorough with primer pocket cleaning, but, some are just a touch above flush. I realize its now time to go with a hand priming tool. My stupid question is can I go ahead and try to shoot these (as I've done before) or should I pull the bullet and redo? My main concern is a slam fire as I close the bolt. What's the best way(s) to get an unfired primer out?

Thanks