How does one go about sitting the bullet depth if have not the correct tools? Can I make a dummy bullet with no primer and seat in shell then close bolt to have it seat against lands then maybe give the die set screw say a 1/4 turn after it touches? Or not a good idea? I should of bought the tools today to make this easier but I forgot about that at the time.

I will be useing Varget and 55gr nosler ballistic tips with starting of 35gr. Max load is 36.5. I just worrie about the bullet on the land and to much pressure building up. If I could take the spring out of my bolt so it falls freely,I could get closer to the idea position. As in this video below. Thanks all for all your help. I have learned alot from here. Thank you, Dan

http://www.youtube.com/watch?v=Jv-D1mEI514