I recently received my new 12 LRP in 6.5 creedmoor. I have decided on a swfa 16x42 super sniper scope, egw hd o moa base and TPS TSR rings. My problem is that I don't know what height rings to get. I want the set up as low as possible to maintain a good cheek weld without having to buy an adjustable. I contacted swfa today and asked them which height rings they recommended, the super low or the low....they ran some numbers and said that the super low rings should work but they couldent guarantee it due to possible bolt clearance issues, the full bull contour barrel etc. I asked the if I could exchange the rings if they did not work and they said only if the scope was not placed in the rings....if the scope was places in the rings than they would consider them used...How else would I be able to tell if they are going to work without at least gently placing the scope in the rings and checking for clearance? I'm not talking about tourqing anything down or even putting the caps on the rings....but you gotta put the scope in the saddle of the rings at least right? The rings run about 80 bucks which to some might not be a lot but is to me especially if I had to eat it because the rings didn't work. Does anyone have this particular rifle and set up or something similar that could give me some advice? Like I said, eating 80 bucks just to see if the rings might work is not something I want to do.