Reply With QuoteYou need to CHECK, and ADJUST if necessary.
PM me if you need instructions.
joe b.
I am converting a Stevens 200 .270 into a 300 win mag. I purchased the mag. bolt head and all other parts needed. Here is the question, do I need to adjust the firing pin protrusion after I install the mag. bolt head?
You need to CHECK, and ADJUST if necessary.
PM me if you need instructions.
joe b.
I just did the same bolt head swap on a Stevens, I didn't have to adjust mine but it was close to max length.
Bob
It's better to shoot for the moon and hit the fencepost than to shoot for the fencepost and hit the ground!
Joeb33050-I would like the instructions. I can't PM you :'(
Send me your email address and I'll send it/themOriginally Posted by Toyoda
joeb33050@yahoo.com
joe b.
i think that when savage sends out a factory rifle it is a good thing to just go ahead and check the protrusion and adjust since it is such an easy process, just to make sure.
Members who have read this thread in the last 1 days: 0
Posting Permissions
Bookmarks