Here goes: I put a lubed 223 case in my 204 Hornady full length sizer die on a rockchucker press ran it up and it resized the neck a little more than half way and it looked very good for the small portion it resized. The Hornady die is bottle necked at the bottom which I am assuming is so it can also be used on a progressive press. My question is this.....there is about 1/4 inch of the bottom of the die that has no threads, if I were to sand that 1/4 of an inch off very evenly would it allow the 223 case to go far enough into the die to resize it enough to be used. I know trying to get out cheap isnt always the answer but every penny counts right now. Thank you in advance for any advice or insight on the subject matter.
Semper Fi
Bookmarks