Just Devcon bedded my Model 10 FP.
Screwed pillars to action after everything was good and waxed up for release. All taoping done to limit Devcon to where I wanted it.
Put Devcon on pillars. Put Devcon on top of front block and in recoil area, a little around the blind mag top, a very little around thr rear pillar bed. That about all you can do anyway. The omportant thin is the recoil lug area, and that goes right into the front pillar block. Rear pillar area is very small, amd my pillar takes up all the area necessary. At least I am sure the pillar itself is not carrying all the load.
So, to answer your question, I looked at the stock and deceided they thought it was important to have plastic around the pillars and recoil lug, I put bedding there.
Larry
Tinkerer
Bookmarks