Good question, I was searching for this info for a while and can't seem to find it. I don't remember it being in the FAQ's anywhere either.
I know this has come up in the past but will ask again....
Will a accu-trigger action fit in a non acuu-trigger stock or vice versa? Both actions are 4.25 spacing and SF, one is accu-trigger and one isnt.
Any info would be appriecated...
Good question, I was searching for this info for a while and can't seem to find it. I don't remember it being in the FAQ's anywhere either.
Probably...
I had an early accu-trigger(4.25, SF) that accepted a Boyd's Laminate as drop in. It needed a little relief work to fit into a Choate US..
The issue is how much they hog-out around the trigger. But don't worry, your knife will be enough to get it fit; IME.
I'm a firm believer in the theory that if it bleeds, I can kill it.
yes it will fit. If anything you may need to relieve a little bit of the stock for clearance of the rear of the trigger, but not always.
”I have a very strict gun control policy: if there’s a gun around, I want to be in control of it.”
~Clint Eastwood
Ok thanks guys. i was pretty sure they would be a fairly even swap. I dont mind doing a little widdling if needed. I appreciate the knowledge you shared
Bookmarks