Been lurking around here for a while and finally got my 1st Savage centerfire, a Model 12FCV in 22-250Rem. Knew I wouldn't have any time to go to the range through the week so I went ahead and took care of that shiny barrel with some Duracoat and did a krylon job on the stock.

Then I set a 4-12x40 Leupold VX-R on top, and a 25" Harris swivel bipod underneath.

Got to the range today, wow what a shooter here's the good.
[img width=576 height=768]http://i94.photobucket.com/albums/l92/bjfergpls/IMG_0065.jpg[/img]
4 groups of 3 each shot at 100 yards with Federal Premium V-Shock. Just using the bipod off the bench, no rear support.

Now for the Bad and the Ugly, had picked up some Hornady 55gr VMax Varmint Express to shoot as well. First shot was fine number two not so good.
[img width=576 height=768]http://i94.photobucket.com/albums/l92/bjfergpls/IMG_0067.jpg[/img]
Recoil felt like a 308, bolt was very stiff, case was stuck and had to be driven out with a cleaning rod and small hammer. The shot jacked up my extractor where it wouldn't pull brass out, I took it apart and got the piece of brass out from under it so that it pulls it back now, but it won't eject. It just drops the brass back in the rifle at the point it should be pitching it out the side.
[img width=576 height=768]http://i94.photobucket.com/albums/l92/bjfergpls/IMG_0063.jpg[/img]
What do I need to do with the bolt to get it ejecting again?