Now I don't feel so bad because no one else knows either. ;D
Can I change the firing pin protrusion with out disassembling the firing pin assembly?
THANKS
Bob
Now I don't feel so bad because no one else knows either. ;D
Bob, If you mean breaking down the bolt then no but if you mean breaking down the pin, spring, washers, and nut then yes if you can compress the spring. I have done it but it is a chore without the correct tools to compress the spring.
Gary
"And you shall know the truth, and the truth shall make you free.” John 8:32 (New King James Version)
Gary thanks for the info.
Bob
Disassemble the bolt and remove the firing pin assembly. Place the assembly upside down on a hard surface and slide a pair of wire strippers between the spring and press down. When you press far enough the silver retainer will fall far enough that the front adjuster will turn to adjust your protrusion. Make small adjustments and check it until you get it set at the correct protrusion
Silence is golden.... duct tape is silver!!
Thanks jglover
Gee now i feel stupid. I got wire strippers all over the place and i never thought about them. I got permanent indents and pinch marks on my fingers.Originally Posted by jglover_81
Gary
"And you shall know the truth, and the truth shall make you free.” John 8:32 (New King James Version)
I can't take much credit for that... blue avenger spelled it all out for me here a couple months ago![]()
Silence is golden.... duct tape is silver!!
Do a search.Jim of PA has a tutorial with pics for that and other bolt procedures.
Bookmarks