Savage 12 fv with the plastic factory stock wanting to take stock off for paint job.they seem really loose.just wanting to put them in right torque spec ....thanks
Printable View
Savage 12 fv with the plastic factory stock wanting to take stock off for paint job.they seem really loose.just wanting to put them in right torque spec ....thanks
If I remember correctly 40 in/lbs
Sent from my SM-G960U using Tapatalk
I dont have the correct answer but I would imagine it is around 20 inch/lbs. If I may offer a suggestion, add pillars prior to the paint job. You can use lampshade threaded pipe to do it on the cheap with some jb weld or other suitable epoxy. I say this because your plastic stock, and most assuredly a plastic trigger gaurd will compress/yield with any effective level of torque.
Thanks guys
This is a short time stock as I'm building funds for a b&c medalist/tactical
From the Savage FAQ:
Accustock models - 40 inch pounds (including wedge screw)
Centerfire w/ synthetic stock - 30-35 inch pounds
Centerfire w/ wood stock - 30-35 inch pounds
Centerfire w/ laminate stock - 30-35 inch pounds
Rimfire w/ any stock - 15 inch pounds
Excellent. ..thanks again
Torqueing the Accustock is a bit more nuanced than setting your torque wrench to 40 in-lbs and getting to work. The last page is what Savage recommends.Quote:
Originally Posted by kcb38
https://www.americanrifleman.org/Web...eaccustock.pdf