Anyone know of an aftermarket charging hamdle that will fit the MSR10 Hunter?
Printable View
Anyone know of an aftermarket charging hamdle that will fit the MSR10 Hunter?
Any should work
I would question that. Savage's MSR10 platform isn't the same as an Armalite or DPMS AR10 platform. IIRC Savage shortened up their receiver set 1/2" or so to make it more compact and shave some weight. In other words, I'm pretty sure some of their parts are proprietary and since the charging handle is dependant on receiver length it would fall into that category.Quote:
Originally Posted by Balljoint
Unfortunately, the Badger tac latch doesn't fit the factory handle either.... roll pin is bigger on the MSR and its shaped differently with a detent for the spring.
Strangely that doesn't surprise me. I often think the engineers at Savage change things for no other reason than to try and justify their paychecks. Can never leave something that works as it should alone, yet at the same time can't be bothered to address/fix the things that actually need fixed.Quote:
Originally Posted by MaD HuNGaRIaN
What is the problem with the charging handle?
Thanks, Barney
Just like GI handle, it’s sub-par. Tiny latch that you can’t grab well with gloves on if you have a large optic mounted.
Sent from my iPhone using Tapatalk
MaD, Thanks for your input.
Barney
I did get a badger latch to work but had to ream the pin hole.
Sent from my iPhone using Tapatalk
Good to know!
Will this charging handle work? I am finding AR15 parts are fitting on my MSR 10 rather then AR10 parts:
https://blackhawk.com/products/long-...harging-handle
No, an AR-15 handle will not work in an MSR-10z
Sent from my iPhone using Tapatalk
I noticed this bump being a lot closer to the tip than some of the others that are more toward the middle. Also a tad bit shorter.
Here is a picture of the factory MSR 10 CH vs an AR15.
https://imgur.com/RMienxq
https://imgur.com/dSKoBIZ
https://imgur.com/577Ek8J