Any advice out there for reaming out the chamber on my mark 2? Just sort of want to deburr it a bit. The edges of the chamber are so square and sharp, its affecting feeding. Dont want to spend 120 bucks on pro tool, what have you folks used?
Printable View
Any advice out there for reaming out the chamber on my mark 2? Just sort of want to deburr it a bit. The edges of the chamber are so square and sharp, its affecting feeding. Dont want to spend 120 bucks on pro tool, what have you folks used?
You can use a cratex rubber abrasive point on a drill. They make some in a bullet shape that screws on the end of a threaded mandrel. You will have to make an extention to get it all the way through the receiver though.
Looked that up, perfect solution, thanks a lot.