I have a Mod 112, cal Rem 22-250. 2nd Round jumps out of magazine too high and will not feed. Causes jam....3 and 4 remain normal
Printable View
I have a Mod 112, cal Rem 22-250. 2nd Round jumps out of magazine too high and will not feed. Causes jam....3 and 4 remain normal
Make sure all cartridges are fully seated to the rear of the magazine. Or load only 3 rounds. If this doesnt help, >>
I would bend the magazine lips in a tiny amount. Think thousandths. Before starting, take measurement from lip to lip. This is where the cartridges sIts.
I measure with an RCBS dial caliper.
This Youtube guy is bending lips out. You want to bend them in. https://youtu.be/eDqBlqpdxCI
Someone deleted my earlier thread here.
You can tell a lot by moving the bolt slowly and watching what happens. With that knowledge you can apply the suggestion above with a greater purpose.
Thanks guys, I am reminded of a similar problem with one of my Mod 11's a couple years ago......yes, I bent the lips a tad and problem was resolved. I wanted a warm and fuzzy thatQuote:
Originally Posted by Prairie Dog hunter
I was doing the right thing. I shall attempt another fix
I have a kimber 7mm-08 that has an internal box mag that feeds the first one perfect and the second one is always too low, but feeds the third one just fine. I am hoping that i can adjust that as easy as my AICS mags. With the AICS mags that feed lip adjustment tool makes it SOOO easy. If you don't have one get the tool!!!