Printable View
Just installed a Jard 7-12 oz trigger in my 12 Target 6mm Dasher, when I removed the original red blade trigger, I found a tiny ball bearing on the table and have no clue as to where it goes on the old trigger ? Bothered me enough that I went thru the Jard parts break down to make sure it wasn't from the new trigger.....(it wasn't) I have looked for a exploded view of the red blade trigger, is there one out there? Thanks for any and all help, rsbhunter
Not from trigger. Are you interested in selling red blade trigger ?
Where you might find a small ball bearing on your Savage 110: Under the extractor on the bolthead(one of them). in the rear baffle of the bolt assembly(2 of them)
I might sell the trigger after I find out if I like the Jard ..... I know its not the extractor ball as that's still together, and the shroud wasn't disassembled .....so I'll just keep guessing.... Everything works as it should, so its not a big deal...Thanks for the help....I thought it was a detent ball for the 3 position safety..but that works normal...rsbhunter@yahoo.com
What is the diameter of the ball?