model 10 trigger group help...
Hi folks, I need some help on a model 10 trigger group.. I am inletting the cheapo plastic stock for Devcon bedding, and of course I took the trigger group off of the action... There is a small straight wire spring that has a 90 degree bend on the end that that goes somewhere on the right side of the group.. Does anyone know where it goes.. If you have an illustration on where the blasted thing goes I would appreciate it.. Strange trigger group...
Thanks
mtnsmith.........................
Re: model 10 trigger group help...
...lol..It's your trigger wire...Slide the 90 degree angle in the allen set screw..The other end should be above the pin sticking out of the rear of the trigger..
Re: model 10 trigger group help...
Quote:
Originally Posted by mtnsmith
Hi folks, I need some help on a model 10 trigger group.. I am inletting the cheapo plastic stock for Devcon bedding, and of course I took the trigger group off of the action... There is a small straight wire spring that has a 90 degree bend on the end that that goes somewhere on the right side of the group.. Does anyone know where it goes.. If you have an illustration on where the blasted thing goes I would appreciate it.. Strange trigger group...
Thanks
mtnsmith.........................
Its the trigger weight of pull / reset spring.
Pictures.....http://savageshooters.com/SavageForu...c,19414.0.html
Bill
Re: model 10 trigger group help...
Thanks guys your replies were very helpful.. I couldn't find any schematics that would help with that, it seemed simple but I didn't want to get it wrong.. I appreciate it..
Thats why I love this forum, folks pitch in to help..
mtnsmith....