A friend wants me to make some 6mm 284 cases for him from new 284 cases. My question do any of you make them and if you do do you use an intermediate die such as a 260 neck die,or just go from 284 to 6mm. Thanks for any help Gordon
Printable View
A friend wants me to make some 6mm 284 cases for him from new 284 cases. My question do any of you make them and if you do do you use an intermediate die such as a 260 neck die,or just go from 284 to 6mm. Thanks for any help Gordon
I would definitely do an intermediate step. Also you may have to some neck turning to get them into specs. It is a much easier process to start with new 6.5-284 brass, that is a simple run through the 6-284 die and your good to go.
I have a 260 AI Rem. neck sizing die I will use it in between the 7mm and the 6mm dies. Thanks for the info. it is really hard to find the 284 brass much less 6.5 284 around here.
you shouldn't have much problem getting them down to where they need to be. I have taken them down in one step but had some cases collapse, and they just don't turn out looking quite as nice. Good Luck
Quote:
I have a 260 AI Rem. neck sizing die I will use it in between the 7mm and the 6mm dies
Will the 284 case fit in your 260 AI die?
I think they will if not I have a set of 6.5-284 dies that will work. I use the 6.5-284 seating die to seat the bullets in my 260 AI.
you should be able to run them straight through your 6.5-284 die if you use some good case lube (not the aerosol stuff). Then from there through the 6mm