PTG Bolt Head Firing Pin Hole Issue
OK, searched and didnt see this sooooo here it is...
Older 110FP in 300WM as a donor action...
Ordered a new PTG .473 Bolt Face for LA .500" lug...
I see where some people have an issue with small vs large firing pins and have to drill out the shank with a #25 (.1495") bit...not the problem here...its the actual firing pin portion of the firing pin will not fit into the new PTG firing pin hole...the shaft of the firing pin fits perfectly into the shank and then seems to strike the shoulder of the hole from the inside...so...what do I do? Drill the firing pin hole itself? If so what size?
ETA...just put a mic on it as near as I can tell its .070" ARE THERE TWO DIFFERENT SIZE FIRING PIN HOLES?
Thanks
Capt Beach