I was going to give head spacing a go this evening and was wondering how to remove the extractor on a 116 model. I have seen some instructions on the web but those are not detailed enough for my taste.
Any ideas?
Thanks,
Shawn
Printable View
I was going to give head spacing a go this evening and was wondering how to remove the extractor on a 116 model. I have seen some instructions on the web but those are not detailed enough for my taste.
Any ideas?
Thanks,
Shawn
Why remove the extractor to headspace?
The extractor basically just slides out towards the outside of the bolthead, popping off over the detent ball. Watch out though, the ball and spring underneath are small and can go flying and become lost. Best to do it inside a plastic bag or something.
The main reason for removal is I was told that head spacing would be more precise with the extractor removed. I would prefer to not remove it if I don't have to.
Update: I got the extractor removed... Placed the bolt in a bag and walla!
Thanks,
Shawn
I have done tons of barrel swaps, never removed one yet. Just be sure to put your headspace gauge under the extractor and help it into the chamber, that way you are sure its against the face of the bolt head.
Thanks!
If you're checking headspace, that must mean it's picture time! Let's see that bad boy!!
This might help for future reference of Extractor removal.
CLICK HERE
That rocks! Thanks..Quote:
Originally Posted by bootsmcguire
Hotolds, I was almost ready to begin the head spacing when all of a sudden, I decided the receiver needed some tlc with 400 grit sand paper.. If all goes well, I should have the thing head spaced tomorrow afternoon.
Cheers!
Shawn
Get a Manson headspace gauge with the Ejector cutout, then you don't have to remove the Ejector. No need to remove the Extractor.
This is what you want. http://www.brownells.com/gunsmith-to...prod25179.aspx