Weaver T36 on Savage mark II BV?

Anyone here use a T36 on their Savage? I am looking for suggestions on Ring height and whether new mounts will be needed.

Thanks

I have Millitt med with that same set up, the high rings are 1/8" higher,

Tanks Dean

So you are using the factory bases and Millett medium rings and a T36 on your BV? Whats the clearance like?

Thanks

If you're using a T36....get signature zee high. If weight is an issue, get Kelby standards

Sent from my DROID X2 using Tapatalk 2

Weight is not an issue. I have been thinking about using the burris just wasnt sure which height. Will I be able to use the factory bases on the BV with the High Burris rings or will I still need higher bases? This Rifle is for my Cousin as I already have a 40x setup with a T36 and Burris Signature Zee Rings

The Burris high rings are almost .600 you should be fine with those.

Tanks Dean

How high is it from the top of the barrell to the top of the factory bases?

Thanks

On my rig the barrel is flush with they action, and then steps down 8" further down the barrel, but the scope bell is over the flush part.

Tanks Dean