Got My Axis 30-06 Sighted In!

Took my new rifle out to the range yesterday morning to get it sighted in. I followed all the instructions for the trigger job which I can't begin to describe the difference! My rifle came with the factory mount and rings. If I did it over again I would purchase one without the factory mounted rings, and purchase an aftermarket ring and mount so I could have a 50mm scope. Also my gun shot horribly low and would not hit the target at 40 yards. I moved to 10 yards and got it on the paper. Back to 50 and then zero'd it in. To finish I moved out to 130 yards (where the bench/target was already set up). I'm shooting one inch high at 130 yards which is good for deer hunting! Not bad for a cheapo rifle!

[img width=576 height=768]http://i32.photobucket.com/albums/d2/smurphy_3/2011-12-20102621.jpg[/img]