Printable View
Was gifted a Stevens Model 330 (Thanks to Mad Dog for identifying) and it has a lacquer like black paint on part of the metal that houses the trigger, hammer etc. (Receiver ??) Guess previous owner wanted to cover up some rust or whatever. Wish to remove the paint, but do not know what solvent to use and best application method:confused: The metal has what appears to be a case hardened finish and do not want to damage the metal surface. Any recommendations would be greatly appreciated.
My first thought would be to use a heatgun. heat until you see wrinkle and scrape with plastic puddy knife.
BB68: Thank you for your post. Any recommendation on a particular heat gun. Know there are many brands available and if you can guide me in the right direction on a purchase, it would be appreciated. Thank you !!
I have used a few different ones, dont recall any brands. They were focused more toward auto bodyshop usage. I probably dont have to mention this, but youre going to want to practice a little before trying on the gun.
BB68: Will study up on the brands. Am glad You did mention that it would be wise to practice a little before trying on the gun. This would be my first experience with a heat gun, and do not want to create another issue. Thank you again for your help.
Try Harbor Freight for a heat gun, notprofessionalgrade but perfect for hobbyist and won't cost an arm and a leg. https://www.harborfreight.com/catalo...2Cf&q=heat+gun
Make sure you remove the buttstock and forend from the gun before you put heat to it. Wouldn't want you inadvertently charring it or bubbling up the finish.
Big Al1: Thanks for the tip on Harbor Freight. One located about 4 miles from my house. Do not want to put a lot of money into it, as this may be a one time use only. Appreciate !!
J. Baker: Appreciate the suggestion in removing buttstock and forend. I can easily see where the extreme heat would bleed over to the wooden pieces. Going to follow your advice and your quote from John Wayne. Don't want to be stupid. Thank You !!
Might as well grab a cart when you go to HF!! That place is the Devil!! You'll find stuff you didn't know you needed!!:cool:
If it's lacquer paint, lacquer thinner will dissolve it.
sharpshooter: Pretty certain it is a lacquer paint. Had considered the thinner, but was concerned it may etch or discolor the finish. Appreciate your post. Going to study this a little more.