Edge/axis LA scope mount red loctite.

The WECSOG genius I purchased my long action Edge from used red Loctite on the crappy aluminum scope mount screws. What are my options before I commit to re-drilling and tapping for larger screws on the receiver$? I'm nervous abut heating the receiver never having done it before. Is there a chemical that would dissolve the red Loctite without eating the receiver also?

Gorilla force is not really an option with tiny little Allen head screws either. What to do? http://i1274.photobucket.com/albums/...ps3bf8314d.jpg

You could try spot heating the screws if you have a fine enough torch tip.

Good idea DrTunder88, burn it out. I wonder if my old soldering iron would get hot enough to beat this crap?

jeff
we use loctite products frequently in automotive apps,,,, the red can be tough to get loose,,,you might check with loctite to see if there is a viable solvent and what critcal temp it melts at,,,,,,, that said ,,,, i like the soldering gun idea,,,, give it plenty of time,,, second idea, insert an allen wrench , use a torch to apply the heat to the wrench thus transfering the heat to the screw , i would use a second cold wrench to unscrew the screw with,,, good luck

Quote:

---

Originally Posted by Jeff Custer

Good idea DrTunder88, burn it out. I wonder if my old soldering iron would get hot enough to beat this crap?

---

You can try the iron but a propane torch with a fine tip will work better. No, you won't hurt anything. Pull the BA out of the stock, heat the screw heads while putting some pressure on the allen wrench. When it lets loose keep going. Don't forget to run a tap through the holes to clean out the LT.

Bill

Soldering iron worked much to my surprise considering the lower temp of electric iron vs that of a torch. A bit of thread clean up and it will be totes. Thanks for the help folks.
cheers
http://i1274.photobucket.com/albums/...ps52d63af3.jpg

I have been referring to my Edge/Axis as a long action but I have read elsewhere there is only one action length. Is it true there is only one action length for Axis rifles?

Yes, that is true.

Quote:

---

Originally Posted by upSLIDEdown

Yes, that is true.

---

and if it isn't obvious, they are long actions.

They did it to cut costs. No need to make two actions if one will work.

The magazines and magazine wells distinguish the "longs" from the "shorts" among Axises.

Good to know a soldering iron works!

Glad you get it done with a soldering iron....

just an FYI I use a hair dryer to remove screws with Loctite on them.