I have an old 110 long action and need an internal mag to feed 22-250. I have a 223 mag that just quite will not fit the 22-250. It has a welded in block in the back of the mag.
Printable View
I have an old 110 long action and need an internal mag to feed 22-250. I have a 223 mag that just quite will not fit the 22-250. It has a welded in block in the back of the mag.
You need a few of the parts here. You’ll probably need the follower as well. https://www.gunpartscorp.com/gun-man...110-parts-list Getting the exact parts you need is difficult. You could also just buy a cheap plastic stock that people discard after replacing with a Chassis. I gave mine away to some someone here years ago.
My advice would be to break the welds on the block & remove it.
A .223 mag won't feed a 22-250 even with the block removed. The whole magazine is narrower.
This site has so much great information if you take the time to look for it.
https://external-content.duckduckgo....3D1&f=1&nofb=1
Acquiring one of these can be tough.
I have had at least two blind mag long actions with the 30-06 magazine boxes in them and they would feed 22-250 AI rounds reliably. I haven't shot any 22-250 fire forming rounds through them for many years, but my best recollection is that they fed OK, or if they didn't feed the full 5 out of the mag, they would at least feed two loaded by themselves, without jamming. If I can find some 22-250 cartridges I will check function with them.
EDIT:
I found some 55 grain soft point Hornady 22-250 factory ammo and tested them in an older long action with the 30-06 blind mag box. It will only feed 3 rounds before the following round nosedives into the mag box. After thinking back to 20 years ago since my original comment, when I had one chambered in 22-250 was that I would have only 2 in the mag box as the 3rd would sometimes nosedive and the 4th always failed.