Re: Savage 116 Stock issue
Get a wood screw one size larger and screw in place.Really no need to remove as it only holds the trigger gaurd on.
Re: Savage 116 Stock issue
I may have to as a last resort. I would like to make it a little more solid though.
Re: Savage 116 Stock issue
Fill the existing hole with two-part epoxy and wait for it to fully cure. Drill a new lead hole the size of the shank on your existing screw. Coat the screw threads with wax and carefully turn it in. It won't be much more solid than the original, but at least you have some virgin material for the threads to bite - you have to be careful about overtightening that screw. It also helps to tighten down the action bolt (at the fromt of the trigger guard) first so you get a good sense of the amount of tension for installing the rear screw....
Elkbane
Re: Savage 116 Stock issue
This is the way I would do it. First I would drill a significantly larger diameter hole than is already there. Then fill the hole with JB Weld or Devcon 10110 steel epoxy, I would coat the trigger guard with Kiwi neutral shoe polish or car wax. I would tape the guard tightly into place. Then I would coat the screw with kiwi or wax and install into place. Once it all has dried you will have a real good anchor point for the screw.
Charlie
Re: Savage 116 Stock issue
Quote:
Originally Posted by Harriershot
This is the way I would do it. First I would drill a significantly larger diameter hole than is already there. Then fill the hole with JB Weld or Devcon 10110 steel epoxy, I would coat the trigger guard with Kiwi neutral shoe polish or car wax. I would tape the guard tightly into place. Then I would coat the screw with kiwi or wax and install into place. Once it all has dried you will have a real good anchor point for the screw.
Charlie
This is just my oppinon but i think if you do it this way. if you screw the screw in before your material dries it would prob be lose or move. I would wait for epoxy to dry then drill pilot hole, wax screw, and put in place and dont over tighten