Need to know what to torque scope mounting rail and also scope rings, base and top pieces.
Savage model 10T.
Do need to use blue loctite?
Thanks
CurtisB
Printable View
Need to know what to torque scope mounting rail and also scope rings, base and top pieces.
Savage model 10T.
Do need to use blue loctite?
Thanks
CurtisB
I don't know how tight to do rings. I just use the short end of an allen wrench finger tight (as tight as I can get them, turning with the short end so there's not too much torque / leverage applied). I use the long end of the wrench for heavy torque / leverage on the base screws. Unlike the rings, as long as they don't strip, it can't be too tight. I always use blue Loctite for all the screws for the base and rings.
15 to 20 in # you should be good to go
If it's aluminum, I only go 15 in-lbs. Purple Loctite is better suited for small screws like those on scope rings and mounts, but blue will do if that's what you have. Blue is designed for fasteners 1/4" and up, whereas purple is for smaller screws.