I need a bullet puller that a WSM case will fit in. These big fat cases will not fit inside the RCBS hammer, Frankfort Arsenal hammer of the Foster collet puller. 30 rounds of test loads were spilled and mixed :(
Printable View
I need a bullet puller that a WSM case will fit in. These big fat cases will not fit inside the RCBS hammer, Frankfort Arsenal hammer of the Foster collet puller. 30 rounds of test loads were spilled and mixed :(
Get a RCBS Collet Bullet Puller
Midway has them. No mess.
You have had WSMs in it? These are .555 at the wide spot.
Well..... I have the RCBS and use it on my 223WSSM and my 6.5X300WSM.
The rcbs bullet puller die is the best mistake corrector I have ever bought.
Hey Greg,
I ran into this same problem, and I found a solution. I used my hammer, but I modified it a bit. I put the shell holder out of my press on the end of the case, this allowed me to get enough of the case inside the hammer, and screw the cap on. I then rapped it, and the bullet came out. The case slid down a bit more into the hammer, so the first few I had to use a pair of plyers to pull on the shell holder, after 5 everything fit together and came apart with ease.
I'm not going to make any comments about "Primitive Pete"....
I think the 82 is a good guy.
A little crude, but a good guy.
OK, Upon taking it apart to remove the rubberband collet, I found I had burrs on the inside of the hammer keeping the cases from going in. Dremmeled the burrs and switched to the #5 shell holder and everything fit like a charm! I almost think this is faster or as fast as messing with that other thing that always wanted to turn sideways and jamb. I may never use it much again. Either way your taking the nut off to empty the tool.
Thanks Pat!