Mounting 8x32 night force on new 110ba 300 win mag.
At zero shooting for feet high.have to raise Turret up to lower it.
Never seen this happen before came of AR-15 245 short mag work fine there puzzled,
Printable View
Mounting 8x32 night force on new 110ba 300 win mag.
At zero shooting for feet high.have to raise Turret up to lower it.
Never seen this happen before came of AR-15 245 short mag work fine there puzzled,
Could you explain that a little better?
I am raising (up) to shoot lower Can not figure out what is going on.
The Riffle Is new took the scope off of my AR .243 short mag. Has the night force solid mount so i never removed scope from mount.
installed it on the new savage 110ba 300 win mag.Put a 6 inch red bulls eye on a piece of paper 2 feet wide ad 4 foot long,
Thought i would hit near the target and adjust zero. Not a mark on the paper at 100 yrds.
Bore sighted it. cross hairs 4 feet over everything.
scope set a lowest mark started raising turret. 40 min up it lowered hit to top of target not bulls eye.
was shooting 150 grn Winchester factory bullets.
Primer blown out of 4 round Gun jammed Had to take cleaning rod and drive cases out of chamber.
About now I am wondering what I spent 4k for gun and scope for.
I am not new to shooting 80 years old and have been reloading and shooting for 60 years.
Today was the worst day I ever spend on the range.
Took the 1885 Winchester in 45/70 out and started hit the mark at 300 yrd Iron sight.
So much for my modern Marva l .
The NF Unimount setup is pretty high, mechanically re-zero (both elev and win) your scope then on bags or bipod bore-sight or laser cartridge the target and crank the scope to it and then start. If that does not put you within 3 or 4 inches at 100 something else is going on.