Printable View
I have a 10fp h&s that has about 600 rds through it. The issue I have is when I close the bolt with any force the Sear is released, getting caught by the accuRelease. Changing the trigger pull weight doesn't help. I did notice that the pin that holds the trigger assembly in was bent. I Fixed the pin, and it did not fix the issue. Working the bolt all easy is not a solution for me. Anyone know how to fix this other than just putting an aftermarket trigger on it? Thanks.
check to make sure the trigger assembly isnt rubbing against the stock anywhere.
It still does it with the action out of the stock. I like the Accutrigger and hadn't planned on changing it, but I might later on. Being that I just picked up a m1a Im hoping there is a way to fix this other than throwing money at it.
How about getting Savage involved?, it shouldn't cost you anything.
Sounds like a trigger pull weight issue to me.......how much did you change the pull weight?
Well before I straightened that pin i could adjust the tigger and it would still release. I fixed the pin, and added a little trigger weight, it does it less. Still not 100% though. Good enough for now though thanks for the imput.