Re: ? about swapping barrels
back off just enough to remove drag & smooth bolt lift.
Re: ? about swapping barrels
From what I have gathered from reading with a taped go gauge you have it
Correct the bolt will act like it will close not even half way like you stated with tape on the go
Gauge I think there was a misread ^ please correct me
If I'm wrong
Re: ? about swapping barrels
The only other check I would do is to full length resize a piece of brass in your die if you will be reloading. Make sure the bolt will close on the resized brass, if not you will need to back off the barrel a tiny bit.
Re: ? about swapping barrels
Quote:
Originally Posted by kslefty
The only other check I would do is to full length resize a piece of brass in your die if you will be reloading. Make sure the bolt will close on the resized brass, if not you will need to back off the barrel a tiny bit.
not a piece of old fired and worked many times brass that is to hard to size properly or brand new that is already undersized.
Re: ? about swapping barrels
Once fired and full length sized in your own die is the best way to go.