Needed to open mounting holes on my new EGW HD base
After many weeks of waiting for a backorder on a EGW HD 20 moa base for my 10-fcp-k it finally arrived today.
Well the mounting holes seem to be slightly off as they didn't line up exactly on my rifle.
The misalignment was enough to cause a bit of binding when tightening the the mounting bolts.
So the fix was to take a .147" bit and open up the holes on the mount just ever so slightly.
Anybody else have this situation with their EGW or any other one piece base ?
Does anybody know of any issues opening the holes slightly may cause ?
Re: Needed to open mounting holes on my new EGW HD base
Is the base off or the receiver?
Realize that if you open up the holes, you'll be hard pressed to make sure that the base is straight on the receiver. Also you have to ensure adequate contact surface with the screws to ensure that the base doesn't move around. If it does move, precision is right out the window since the base will move between shots and your POI will move with it.
Re: Needed to open mounting holes on my new EGW HD base
The base has counter sunk holes so the screws still have plenty of mating surface.
Re: Needed to open mounting holes on my new EGW HD base
You'll have to "adjust" the countersinks as well or the screws will just recenter themselves with relation to the old holes.
Re: Needed to open mounting holes on my new EGW HD base
Yep I understand that, but for some reason just opening up the holes slightly relieved the binding when installing the screws.
Not perfect but I believe a workable solution as the screws tightened nicely at 20 inch pounds.
Re: Needed to open mounting holes on my new EGW HD base
You should be fine. The misalinment is more than likely a warpped action. It happens.